Causes And Rectification Of Faults; Disposal Of The Old Device - Caso Various 2000 2002 Originalbetriebsanleitung

E1, E2, Electrical failure. Contact customer service.
E6, E8
E3 Over-voltage. Contact customer service.
E4 Low-voltage. Contact customer service.
E5 Overheating Protection
This means that the temperature had increased to a temperature of 270°C. In
this case the device turns off automatically in order to avoid damages.
In case of "E5" please pull the power plug in order to reset the device. After this
you can use it again as usual.
Please note
► If error messages continue to be displayed after an extended waiting period or after
restarting the appliance, then it must be sent to Customer Service to be examined.

16.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Display is empty
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

17 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the
environment.
Therefore, do not put your old device into the non-recyclable waste under any
circumstances.
Please note
Utilise the collection point, established in your town, to return and recycle old electric
►
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
caso Various 2000
Possible Cause
Power plug not plugged in
Fuse switch not switched on
To Rectify
Insert plug into mains socket
Switch on fuse switch
44