Silvercrest SEMR 850 A1 Bedienungsanleitung Seite 6

GB / IE
• Never direct the steam or hot water jet towards parts of the body;
handle the steam/hot water spout with care: risk of scalding!
• The outer metallic parts of the appliance and of the filter holder must
not be touched with the appliance in operation, because it could
cause burns.
• If water does not come out of the filter holder, it may be because the
filter is clogged. Stop the brewing and wait ten seconds. Remove and
disconnect the filter holder because any remaining pressure could
cause splashes or squirts. Then clean as explained in the relevant
paragraph.
IMPORTANT possible damage to materials
• Place the machine on a stable surface where it cannot be knocked
over.
• Never use the machine without water because the pump will burn out.
• Never fill the water tank with hot or boiling water.
• Do not place the machine on very hot surfaces or near open flames
in order to prevent damage to the body.
• The cable must not touch any hot parts of the machine.
• Do not use sparkling (carbonated) water.
• Never put in the filter substances other than coffee powder. They
could cause serious damage to the appliance.
• Do not leave the machine at a room temperature below 0 °C because
the water remaining in the boiler could freeze and cause damage.
• Never use the appliance outdoors.
• Do not expose the appliance to atmospheric agents (rain, sun, etc...).
• Before cleaning the appliance always unplug it and allow it cool
down. Clean only with a non-abrasive cloth that has been slightly
dampened with water, adding a few drops of mild, non-aggressive
detergent (never use solvents that damage plastic).
6 GB / IE
WARNING: risk of burns
from high temperature steam