Troubleshooting - Silvercrest SEMR 850 A1 Bedienungsanleitung

If there are problems with operation, immediately turn off the machine and
unplug it from the socket-outlet.
PROBLEMS CAUSES
The coffee There is little water and the
maker does pump does not suck it up.
not supply
The steam exit hole on the dis-
steam.
penser wand is clogged.
Coffee over- Probably an excess amount of
flowing from ground coffee has been placed
the edges of in the filter ring preventing the
the filter ring. filter ring from being correctly
tightened into its housing.
Residues of ground coffee have
remained on the gasket of the
filter holder coupling seat.
The exit holes of the filter
containing coffee grounds are
clogged.
The coffee is The holes of the perforated disc
not supplied in the filter holder coupling seat
or flows too are clogged.
slowly.
The exit holes of the filter
containing coffee grounds are
clogged.
The coffee blend is ground too
fine.
The coffee blend is pressed
down too much.
The tanks is not inserted well.
There is little water and the
pump does not suck it up.
The coffee is The blend has been ground too
too watery coarsely.
and cold.

TROUBLESHOOTING

SOLUTIONS
Check that the water level in the tank is correct. If
necessary, fill it with cool tap water.
Unclog any deposits that may have formed in the
hole of the steam tube with a pin (Fig. 14).
Slowly remove and disconnect the filter holder
because any remaining pressure could cause splash-
es or squirts. Clean the coupling seat with a sponge
(Fig. 13). Repeat the operation placing the correct
quantity of coffee in the filter.
Clean the seal with a toothpick or a sponge (Fig.
13).
Slowly remove and disconnect the filter holder
because any remaining pressure could cause splash-
es or squirts. Clean the clogged filter holes with a
small brush or a pin.
Turn on the machine without the filter holder, making
the water run. Turn on the machine without the filter
holder, making the water run. If the water still does
not come out from all the holes evenly, carry out the
descaling cleaning operation, following the instruc-
tions provided in the package.
Slowly remove and disconnect the filter holder
because any remaining pressure could cause splash-
es or squirts. Clean the clogged filter holes with a
small brush or a pin.
Try using coarser coffee blends.
amper coffee inside the filter using less pressure.
Fit the tank securely by pushing it as far as it will go.
Check that the water level in the tank is correct. If
necessary, fill it with cool tap water.
A more finely ground blend must be used to obtain a
more concentrated and hotter coffee.
GB / IE
IT
GB / IE 13