Input Rename - Yamaha RX-V563 Bedienungsanleitung

SET MENU

■ Input rename

B)INPUT RENAME
Use this feature to change the name of the input source
that appears in the OSD and in the front panel display.
2 INPUT MENU
B)INPUT RENAME
DVD
p
[ ]/[ ]:Position
[ ]/[ ]:Chara.
1
Press one of the input selector buttons ( 3 )
or D MULTI CH IN to select the input
source you want to change the name of.
USB
CD MD/CD-R TUNER
DVD DTV/CBL DVR
V-AUX/DOCK
Press 4 AMP and then press 7 l / h on the
2
remote control to place the "_" (underscore)
under the space or the character you want to
edit.
3
Press 7 k / n to select the character you
want to use and then press 7 l / h to move
to the next space.
Notes
• You can use up to 8 characters for each input.
• Press 7 n to change the character in the following order,
or press 7 k to go in the reverse order:
A to Z, a space, 0 to 9, a space, a to z, a space, symbols (#,
*, –, +, etc.)
4
Repeat steps 1 through 3 to rename each
input source.
Press 7 ENTER to exit from "INPUT
5
RENAME".
66
En
-> DVD
[
MULTI CH IN
or
■ Volume trim
C)VOLUME TRIM
Use this feature to adjust the output volume of each
source. This is useful if you want to balance the level of
each input source to avoid sudden changes in volume
when switching between input sources.
Choices: CD, MD/CD-R, TUNER, DVD,
DTV/CBL, V-AUX, DVR, DOCK, USB,
MULTI CH
Control range: –6.0 to +6.0 dB
Control step: 1.0 dB
Initial setting: 0.0 dB
2 INPUT MENU
C)VOLUME TRIM
DVD
p
[ ]/[ ]:Adjust
[RETURN]:Exit
Note
You can only adjust the value for DOCK when your iPod is
stationed in the Yamaha Universal Dock connected to this unit.
■ Decoder mode
2 INPUT MENU
D)DECODER MODE
.
>AUTO
CD
DVD
DTV/CBL ;;;;AUTO
[ ]/[ ]:Up/Down
p
[ ]/[ ]:Select
Decoder select mode
Use this feature to designate the default decoder mode for
the input sources connected to the DIGITAL INPUT jacks
when you turn on the power of this unit.
Choices: AUTO, LAST
• Select "AUTO" if you want this unit to automatically
detect the type of input signals and select the
appropriate decoder mode.
• Select "LAST" if you want this unit to automatically
select the last decoder mode used the connected input
source.
DTS decoder prioritize setting
Choices: AUTO, DTS
• Select "AUTO" if you want this unit to automatically
detect input signal types and select the appropriate
input mode.
• Select "DTS" when you play back a DTS-CD.
DVD
;;;;;0.0dB
[
D)DECODER MODE
LAST
;;;;AUTO
;;;;AUTO
[