Creating Your Original Scene Templates - Yamaha RX-V563 Bedienungsanleitung

Creating your original SCENE
templates
You can create your original SCENE templates for each
SCENE button. You can refer to the preset 16 SCENE
templates to create the original SCENE templates.
■ Customizing the preset SCENE
templates
Use this feature to customize the preset SCENE templates.
Select a SCENE template
SCENE template library
(Image)
1
Turn on the video monitor connected to this
unit.
2
Press and hold the desired 5SCENE button
for 3 seconds.
The SCENE template customizing screen appears on
the video monitor.
AMP
Note
When the SCENE template you want to customize is not
assigned to any of the 5SCENE buttons, press 4AMP
and then press 7l / h repeatedly to recall the desired
SCENE template on the menu screen.
Create the original SCENE
template
1
Assign to the SCENE
button
1
3 seconds
3
Press 4AMP and then 7 k / n to select the
desired parameter of the SCENE template
and then 7 l / h to select the desired value
of the selected parameter.
You can adjust the following parameters for a SCENE
template:
• INPUT: The input source component
• MODE: The active sound field programs,
STRAIGHT or DIRECT mode (see
pages 41 and 43)
• NIGHT: The night listening mode setting (see
page 44)
− SYSTEM: Keeps the current night listening
mode.
− CINEMA: Sets the night listening mode to the
CINEMA mode.
− MUSIC:
Sets the night listening mode to the
MUSIC mode.
4
Press the 5SCENE button again to confirm
the edit.
y
An asterisk mark (*) appears by the name of the original SCENE
template.
Notes
• Once the desired SCENE templates are assigned to the
corresponding 5SCENE buttons, you may need to set the
input source of the SCENE template on the remote control. See
page 34 for details.
• You can create a customized SCENE template for each
5SCENE button, and if you create another customized
SCENE template, this unit overwrites the old customized
SCENE template with the new one.
• The newly created template is only available for the assigned
5SCENE button.
■ Renaming the SCENE templates
Select the name of the SCENE template at step 3
of "Customizing the preset SCENE templates"
and then press 7ENTER.
• Press 7k / n to select the desired character.
• Press 7l / h to place "_" (underscore) under the
space or the desired character.
• Press 8RETURN to cancel the new name.
• Press 7ENTER to confirm the new name.
Selecting the SCENE templates
1
33
En