Troubleshooting; Troubleshooting Table - Blaupunkt 5BD3..50 Serie Gebrauchsanleitung

Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
Insert the lower panel at an angle towards the back (fig. A).
1.
Slide in the middle panel (fig. B).
2.
Stick the retaining clips onto the right and left-hand side of
3.
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).

Troubleshooting

Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.

Troubleshooting table

Fault Possible
cause
The oven does The fuse has
not work. blown.
Power cut
Power cut
The symbol
0
lights in the dis-
play with some
zeros.
The oven does There is dust in
not work. the contacts.
The oven door The oven door
does not open. has been
locked by the
The symbol
H
self-cleaning
lights up on the
function
display panel.
The display The appliance
has been auto-
shows "‰ .
matically
turned off.
40
Solution/advice
Check the condition of the
fuse/circuit breaker in the
fuse box.
Check that the light in the
kitchen and other household
appliances are working.
Set the time once again.
Turn the control knob several
times in both directions.
Wait until the oven has
cooled and the
H
turns off.
.
V
Turn the function control
knob to the zero setting.
Hook the seal in to the bottom of the panel again (fig. D).
4.
Insert the uppermost panel at an angle to the back into the
5.
brackets. Take care not to push the seal to the back (fig. E).
Insert the two small seals on the left and right of the panel
6.
again (fig. F).
Put the cover back in place and screw it on.
7.
Attach the oven door.
8.
Do not use the oven again until the panels have been
correctly installed.
Error messages
When the indicator displays an error message with
the sensor. The message will disappear. The set time
0
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message Possible cause Solution/advice
"‹‚‚
"‚‹‡
"‚‚†
:
Risk of electrical discharge and the resulting shock.!
symbol
Incorrect repairs can be dangerous. Repairs can only be
carried out by qualified personnel from the Technical
Assistance Service.
A sensor has Press all the sensors one
been pressed by one. Check if a sensor is
for too long or stuck, covered or dirty
has got stuck.
The door lock
Press the
has been acti-
can now begin program-
vated with the
ming again.
door open.
The tempera- The door oven is locked
ture inside the and heating has stopped.
oven is too Wait until the oven has
high.
cooled. Press the
and reset the time.
, press
"
sensor. You
0
0 sensor