Environmental Protection; Before Startup; Unpacking; Start Up - Kärcher HD 2000 Super Handbuch

Safety valve
The safety valve opens when the overflow
valve is defective.
The safety valve is set by the manufacturer
and sealed. Setting only by customer serv-
ice.
Parking brake
The appliance is equipped with a safety
brake.
Note
Do not lock the safety brake while driving.

Environmental protection

The packaging material can be
recycled. Please do not place
the packaging into the ordinary
refuse for disposal, but arrange
for the proper recycling.
Old appliances contain valua-
ble materials that can be recy-
cled. Please arrange for the
proper recycling of old appli-
ances. Batteries, oil, and simi-
lar substances must not enter
the environment. Please dis-
pose of your old appliances us-
ing appropriate collection
systems.

Before Startup

Unpacking

– Check the contents of the pack before
unpacking.
– In case of transport damage inform ven-
dor immediately
Attaching the Accessories
Both mounting screws of the slider and
swivel the slider upwards.
Tighten the fastening screws.
Install nozzle with nozzle screw at the
spray pipe.
12
English
Connect ray tube to hand spray gun
Connect high pressure hose to hand
spray gun
Note
In order to avoid twisting the high-pressure
hose, the supplied rotating coupling can be
installed between the high-pressure con-
nection and the high-pressure hose.
Fasten the high pressure hose to the
high pressure connection.
Check oil level
Open the device hood.
The oil level in both the high-pressure
pumps must lie between MIN and MAX.
Do not operate the appliance if the oil
level has fallen below "MIN".
Add oil if required (see technical speci-
fications).
Activate deaeration of oil container
Cut off the tips of the two oil container
covers.
Close cover.

Start up

Electrical connection

Warning
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
The minimum fuse rating required at the sock-
et outlet is (see technical specifications).
The appliance should always be connected
to the electrical mains using a plug. It is for-
bidden to permanently connect the appli-
ance to the power supply. The plug is only
for mains separation.
Check the power cord with mains plug for
damage before every use. If the power cord
is damaged, please arrange immediately