Safety Precautions - PeakTech 1030 Bedienungsanleitung

1. Safety Precautions

This product complies with the requirements of the following European
Community Directives: 2004/108/EC (Electromagnetic Compatibility) and
2006/95/EC (Low Voltage) as amended by 2004/22/EC (CE-Marking).
Overvoltage category III 1000 V / IV 600 V; pollution degree 2.
CAT I: For signal level, telecommunication, electronic with small transient
overvoltage
CAT II: For local level, appliances, main wall outlets, portable equipment
CAT III: Distribution level, fixed
overvoltages than CAT IV.
CAT IV: Units and installations, which are supplied overhead lines, which are
stand in a risk of persuade of a lightning, i.e. main-switches on
current input, overvoltage-diverter, current use counter.
To ensure safe operation of the equipment and eliminate the danger of serious
injury due to short-circuits (arcing), the following safety precautions must be
observed. Damages resulting from failure to observe these safety precautions
are exempt from any legal claims whatever.
* Do not use this instrument for
measurement.
* Do not apply more than the rated voltage of max. 1000 V AC between the
probe tip and earth ground.
* Do not use the unit if it is wet or damaged.
* To avoid electric shock, do not operate this product in wet or damp
conditions. Conduct measuring works only in dry clothing and rubber shoes,
i.e. on isolating mats.
* Never touch the probe tip of the unit.
* Comply with the warning labels and other info on the equipment.
* Do not subject the equipment to direct sunlight or extreme temperatures,
humidity or dampness.
* Do not subject the equipment to shocks or strong vibrations.
-11-
installation, with smaller transient
high-energy industrial installation