PeakTech 1030 Bedienungsanleitung Seite 17

System self-test:
* The "power on" green/red LED & Beeper visually confirms battery sufficiency,
system integrity, and at operation/active mode. Always test on known live
circuit to verify tester functionality prior to use.
1. Checking for the presence of AC voltage:
* Prior to use, test on known live circuit to verify tester functionality.
* Place tip of the tester near an AC voltage. If the tester detects voltage, the
"power on" LED in the tip of the tester changes color from green to red and
a discontinuous beeping sound is generated.
Low battery indication:
* Scenario 1 – Powering on the tester: The "power on" LED in the tip of the
tester changes from a steady green to a blinking green and a series of
beeping sounds is generated. The tester then turns off. The unit is now
deactivated and is not operational; the batteries require replacement. To
replace the tester batteries refer to the Maintenance section titled "Battery
Replacement."
* Scenario 2 – Operating the tester: If the LED lights become dim and the tone
fades, the tester may require new batteries. To replace the tester batteries
refer to the Maintenance section titled "Battery Replacement."
Auto Power Off:
* After 5 minutes of non-use, the tester automatically powers off to conserve
battery life. Listen for a double-beep sound and watch the "power on" green
LED turn off. The tester is now deactivated and is not operational.
Flashlight Operating
* Press and hold the Flashlight ON/OFF button to turn on Flashlight. Flashlight
turned off once the Flashlight button is released.
CAUTION!
Movement generates static voltages. The AC Voltage Detector could react to
this static voltages with short light of the LED and short sound of the Buzzer.
This behaviour is normal and it isn't a defect of the instrument.
-16-