Bevel Cut In Gable Area - Storch ProCut minerals PLUS Bedienungsanleitung

Fig. d: Longitudinal and lateral cut

Bevel cut in gable area

Measure the distance from the glued insulating board to the pitch of the roof - upper and lower dimension (see Fig. f) -
and transfer this to the insulating board. Position the board on the bearing rail (3). Undo the locking screw for the bearing
rail (18, Fig. b). Lift the rail (3) with the insulating board and position the board so that the marked points are vertically
aligned with the cutting guide. Secure the bearing rail (3) in position by using the locking screw (18), then guide the cut-
ting guide (12) to the insulating board and position.
Execute the cut as described above under "Longitudinal and lateral cut".
Note:
Mark the position of the bearing rail and read the number of degrees on the angle scale (9, Fig. b); doing
this will enable you to use the angle again at a later date.
Fig. e: bevel cut
Mitre cut
Use the supplied sliding bevel to ascertain the mitre angle of the object (Fig. g), position the board on the right-hand bear-
ing rail (3) and transfer the angle to the insulating board (Fig. h). Align the rear marking (x) precisely with the height of the
rear cutting guide (12) and loosen the screw (16) for the cutting guide. Position the cutting guide (12) over the insulating
board and fold in the cutting guide (12) until the blade of the cutting component comes into contact with the rear marking
(x) and front marking (y). Retighten the screw (16).
Execute the cut as described above under "Longitudinal and lateral cut".
Fig. g: Mitre cut
Translation of the original instruction
House wall
Insulating board
Fig. f
Fig h: Transferring the mitre angle to the insulating
board
50
upper
dimension
lower dimension