Cutting Variants - Storch ProCut minerals PLUS Bedienungsanleitung

Assembly of the optional freestanding support for the ProCut mineral PLUS 128
Users can purchase the optional freestanding support (Art. no. 57 03 91) for the ProCut mineral PLUS 128. The device
can be used in a freestanding condition with the freestanding support.
ProCut mineral PLUS / ProCut mineral PLUS 128 cutting variants
Longitudinal and lateral cut
Position the insulating board on the right-hand bearing rail (3) and slide the board to the left as far as the cutting dimen-
sion (this is to be read on the measuring scale of the bearing rails (3 + 6)). If you are processing boards with an excessive
thickness, unfold the board support (5) from the right-hand bearing rail. Fold the cutting guide (12) up to the insulating
board (see Fig. c).
Now press the cutting guide (12) firmly against the insulating board, insert the appropriate cutting component (see table
"Selecting the cutting component") through the front and rear guide (12) and begin the sawing motion (only for manual
work - automatically through guiding for the cordless reciprocating saw)..
Note:
Make sure you do not leave the rear guide with the cutting component. Only execute the sawing stroke as far
as necessary. Make sure the cutting guide (12) is pressed against the board firmly and evenly. Always use your
free hand to press just above the cutting component and use your foot to press adequately against the bottom
of the cutting guide (12).
To generate multiple cuts fix the cross-cut fence for repeat cuts (8) on the left-hand bearing rail (6): The board can now be
laid vertically or horizontally on the bearing rail (3 + 6) to produce longitudinal or lateral cuts. If the stop (8) is not required
for other cuts in the meantime, simply fold it away.
Fastening the freestanding support at the bottom
To fasten the freestanding support at the bottom, release
the fastening screws for the base shown, and unscrew by a
couple of thread turns. Push the freestanding support profi-
le with the cut-outs over the thread of the fastening screws
from the bottom onto the square profile of the base and up
to the stop. Then tighten the fastening screws again.
Fastening the freestanding support at the top
The freestanding support is attached to the rear rail with
a clamping device. To do so, loosen the star screw on the
clamp, position the clamp as shown on the angle scale fas-
tening, and then tighten the star screw again.
49
Translation of the original instruction