Setup / Assembly Of The Cordless Saw And Insulation Material Blade / Initial Operation - Storch ProCut minerals PLUS Bedienungsanleitung

Device description - Setup / initial operation
The device is delivered in a transport and storage box.
Do not use the cutting guide (12) to lift the device out of the box. Instead, hold the device by the base plate
(11), lift it slightly and rest the front of the base (cutting guide facing upwards) on the edge of the transport
and storage box.
Now remove the stand (1) from the box and assemble it as shown in the illustration (a) by using the supplied screws (2).
Now lift the device by the base plate and position it at the desired location.
If the device is to be set up on scaffolding (recommended), erect it so that it is positioned centrally in the immediate vi-
cinity of the work area. The device is always leant against a wall, meaning that the space between the wall and scaffold
board is used.
To do this, loosen both of the screws (15) on the rear support and set the desired angle of the support (13). Check to ensure
the device is sturdy and secure.
Now loosen the screw for the mitre angle (16) and fold the cutting guide (12) fully to the left. The bow is now positioned
at 90° to the base plate (11). Retighten the screw (16).
Now pull the cutting guide (12) towards itself. The cutting guide folds upwards at the same time until it arrives at its
stop. The cutting guide is now fully open, thereby enabling boards with a maximum thickness of 30 cm to be processed.
Assembling the guide carriage on the blade
guide
Caution:
The guide carriage can only be inserted into or removed
from the blade guide if the blade guide is fully swivelled
out to max. board thickness:
to install or remove, always remove the cordless reciproca-
ting saw and insulating material blade!
Assembling the insulating material blade on
the cordless reciprocating saw
Press the release button on the saw stop of the cordless
reciprocating saw and pull the stop out of the saw.
Now insert the insulating material blade into the cordless
reciprocating saw's blade holder.
Caution:
The blade is very sharp – wear suitable protective gloves
during assembly.
Rotate the locking ring on the blade clockwise to the stop
and push the rear shaft on the blade into the blade holder
up to the stop; then release the locking ring.
The blade is now locked in the blade holder. Check for cor-
rect seating by lightly pulling out of the locking ring. If the
blade can be pulled out, repeat the assembly procedure.
Translation of the original instruction
2. Pull out
2. Insert blade
46
1. Press and hold