Object Definitions In The Lmit09 For Profibus Dp/V1; Device Model; Cip Range Selection Via Cyclic Output Data Stream - ECOLAB lmit 09 Kurz- Betriebsanleitung

5. Object definitions in the
5.1

Device Model

The data, supplied by the
This described blocks are mapped for access by PROFIBUS.
Block
Equipment block
Temperature block
Conductivity block
Concentration block
Unit block
Product block
The determination of the a-cyclic access-address is as follows
Slot: The slot number can be taken out of the table.
Index: The index of a parameter result of the start-index for the block increased by the
relative index of the parameter (as included in the table of the separate blocks).
The cyclic parameters are transmitted to the PLC according to the table below in the
DataExchange Input datastream:
Octet 1-4
Temperature
Additional, the following information is transmitted from the PLC to the Output datastream:
Octet 1
CIP
The code meaning of the parameters above can be taken out of the individual block
description.
5.2

CIP range selection via cyclic output data stream

Relative Index
9
SP_D:
Value:
Status:
*C_w = cyclic write
417101561_LMIT09_DPV1
LMIT09
LMIT09 are divided into different blocks, according to their logic.
Mapping for the a-cyclic communication
5 6-9
Status Conductivity Status
2
Status
Name Data type Bytes
SD_D Record
Byte 1
Value
Select CIP range as follows:
Code
0
1
2
3
If, in the status byte a value, different from "128" is transmitted,
the CIP value is rejected.
- 19 -
for PROFIBUS DP/V1
Slot
0
1
2
3
4
5
10 11-14 15
Conzentration Status
Access Value Range
2 C_w
2
Status
Meaning
CIP1
CIP2
CIP3
CIP4
Startindex
16
16 17 18
Code Status Product Status
Initial Value
-
Rev. 03-10.12
19