Setting Of The Field Bus Parameter; Transmission Speed (Baud Rate) - ECOLAB lmit 09 Kurz- Betriebsanleitung

4.3.2

Setting of the field bus parameter

The setting of the
the LMIT09 (Art. no. 417101557), who is included in scope of supply at the Documentation-
CD (Art. no. 417101559) befindet.
4.3.3

Transmission speed (Baud rate)

The PROFIBUS-Master
PROFIBUS DP/V1
In case, the data transmission speed has changed, the
switched of and on again to recognise the new transmission rate.
The following bus rates are supported by the LMIT09:
• 9.6 kBits/s
• 19.2 kBits/s
• 93.75 kBits/s
• 187.5 kBits/s
• 500 kBits/s
• 1.5 MBits/s
• 3 MBits/s
• 6 MBits/s
• 12 MBits/s

IMPORTANT
417101561_LMIT09_DPV1
PROFIBUS DP/V1
determines the data transmission speed on the bus. The
recognises automatically the used baud rate of the connected Master.
However the maximum speed should not exceed the 6 MBits/s due to possible
synchronisation problems.
slave address is described in the operating manual for
LMIT09
- 18 -
LMIT09
power supply has to be
Rev. 03-10.12
/