Options - IKEA HJÄLPSAM Bedienungsanleitung

ENGLISH
1)
Programme
3)
4)
5)
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of
dishes can change the programme duration and the consumption values.
2) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase, the
temperature stays at 70 °C for 10 to 14 minutes.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) This is the standard programme for test institutes. With this programme you have the most efficient use of water and
energy consumption for crockery and cutlery with normal soil.
5) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad
odours to come out from the appliance.
Do not use detergent with this programme.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

Options

Acoustic signals
The acoustic signals operate in these condi-
tions:
• When the programme is completed.
• A malfunction occurs to the appliance.
Factory setting: on.
You can deactivate the acoustic sig-
nals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold the programme button
until the programme indicator (A) flash-
es and the programme indicator (B)
comes on.
Degree of soil Programme
Type of load phases
Fresh soil Wash 60 °C
Crockery and Rinse
cutlery
Normal soil Prewash
Crockery and Wash 50 °C
cutlery Rinses
Dry
All Prewash
Duration
(min)
30
120 - 130
11
4. Press immediately the programme but-
ton.
• The programme indicator (A) comes
on with a fixed light.
• The programme indicator (B) starts to
flash.
5. Wait until the programme indicator (A)
goes off and the end indicator comes on
(the programme indicator (B) continues
to flash).
• The acoustic signals are on.
6. Press the programme button. The end
indicator goes off.
• The acoustic signals are off.
7. Deactivate the appliance to confirm.
Activating the acoustic signals
1. Refer to 'Deactivating the acoustic sig-
nals', step (1) through (4).
Energy Water
(kWh) (l)
0.8 8
0.8 - 0.9 12 - 13
0.1 5
7