Troubleshooting - AKG C 1000 S Bedienungsanleitung

To clean the surface of the microphone body, use a soft cloth
moistened with water.
1. Unscrew the front grill from the microphone CCW.
2. Remove the windscreen from the from grill and wash the
windscreen in soap suds.
3. Allow the windscreen to dry overnight.
4. Replace the windscreen in the front grill and screw the front
grill on the microphone CW.
Problem
No sound:
Distortion:
Microphone sound
becomes duller by and by:

5 Troubleshooting

Possible Cause
1. Power to mixer and/or
amplifier is off.
2. Channel or master fader
on mixer, or volume
control on amplifier is at
zero.
3. Microphone is not con-
nected to mixer or
amplifier.
4. Cable connectors are
seated loosely.
5. Cable is defective.
6. No supply voltage.
7. Battery dead/no battery
inserted.
1. Gain control on mixer
set too high.
2. Mixer input sensitivity
too high.
• Internal or external
windscreen attenuates
high frequencies when
soiled.
4 Cleaning
4.1 Microphone
Body
4.2 Internal
Windscreen
Remedy
1. Switch power to mixer
or amplifier on.
2. Set channel or master
fader on mixer or vol-
ume control on amplifier
to desired level.
3. Connect microphone to
mixer or amplifier.
4. Check cable connectors
for secure seat.
5. Check cable and
replace if damaged.
6. Switch phantom power
on.
Check cable and
replace if necessary.
7. Check/insert battery.
1. Turn gain control down
CCW.
2. Connect a 10-dB preat-
tenuation pad between
microphone cable and
input.
• Clean internal or exter-
nal windscreen.
23