Troubleshooting - AKG MicroMic C 417 III Bedienungshinweise

Problem
22
Downloaded from www.Manualslib.com

5 Troubleshooting

Possible Cause
No sound: 1. Power to mixer
2. Channel or master
3. Microphone is not
4. Cable connectors
5. Cable is defective.
6. No supply voltage.
Distortion: 1. Gain control on
2. Mixer input sensi-
manuals search engine
and/or amplifier is
off.
fader on mixer, or
volume control on
amplifier is at zero.
connected to mix-
er or amplifier.
are seated loosely.
the mixer set too
high.
tivity too high.
Remedy
1. Switch power to
mixer or amplifier
on.
2. Set channel or
master fader on
mixer or volume
control on ampli-
fier to desired
level.
3. Connect micro-
phone to mixer or
amplifier.
4. Check cable
connectors for se-
cure seat.
5. Check cable and re-
place if damaged.
6. Switch phantom
power on.
Phantom power
supply: connect to
power outlet or in-
sert battery
(batteries).
Check cable and re-
place if necessary.
1. Turn gain control
down CCW.
2. Connect a 10-dB
preattenuation
pad between
microphone cable
and input.