Ryobi CSD40LI Bedienungsanleitung Seite 7

EN
FR DE ES IT NL
time is required to fully recharge the screwdriver.
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
Remove the product from the charger once it is fully
charged and ready for use.
WARNING
Battery products are always in operating
condition. herefore, the switch should always be
locked when not in use or carrying at your side.
ADJUSTABLE TORQUE CLUTCH
his screwdriver is equipped with an adjustable torque
clutch for driving different types of screws into different
ma te ri als. he proper setting depends on the type of
ma te ri al and the size of screw you are using.
ADJUSTING TORQUE Fig.
here are twelve torque indicator settings located on the
front of the screwdriver.
Rotate adjustment ring to desired setting, aligning num
ber on adjustment ring with arrow on housing.
1 - 2 For driving small screws
3 - 4 For driving screws into soft material
5 - For driving screws into soft and hard materials
8 - 9 For driving screws into hard wood
1 - 11 For driving large screws
For full power applications
D I R E C T I O N O F R O TAT I O N S E L E C TO R
FORWARD REVERSE CENTER LOCK Fig.
he direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With
the screwdriver held in normal operating position,
the direction of rotation selector should be positioned
to the left of the switch trigger for forward motion.
he direction is reversed when the selector is to the right
of the switch trigger.
Setting the switch trigger in the OFF (center lock) position
helps reduce the possibility of accidental starting when
not in use.
o stop the screwdriver, release the switch trigger and
allow the collet to come to a complete stop.
OPERATION
QUICK CHANGE CHUCK Fig.
A quick change chuck mounted on the screwdriver is
easy for inserting or remoring the bits. o insert a bit,
insert the bit into collet till lock. o remove a bit, simply
pull the sleeve of collet forward.
PT DA SV FI NO RU
English
PL CS HU RO LV LT
SPINDLE LOCK
he screwdriver spindle is locked when the On/Off switch
is not pressed.
his enables screws to be screwed in, even when the
battery is empty.
GRIP ZONE
Soft grip reduces the danger of slipping and thereby
improves the grip on the tool and handing.
At the same time, he rubber coating achieves a
vibration-reducing effect.
LED WORKLIGHT Fig.
he screwdriver has a built-in LED worklight. his feature
is convenient when working in close or tight areas where
additional light is needed. Whenever the switch trigger is
depressed, the LED worklight will illuminate.
NOTE: During normal operation, if the LED worklight will
not illuminate, charge the screwdriver.
MAINTENANCE
WARNING
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING
Always wear safety goggles or safety glasses
with side shields during product operation or
when blowing dust. If operation is dusty,
also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts.
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. hemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Do not open the battery yourself. here is a danger of
short circuit.
3
ET HR SL SK EL TR UK
ost