Intended Use; Residual Risks - Ryobi CSD40LI Bedienungsanleitung

EN
FR DE ES IT NL
Safety, performance, and dependability have been given
top priority in the design of your screwdriver.

INTENDED USE

he screwdriver is intended to be used only by adults who
have read and understood the instructions and warnings
in this manual, and can be considered responsible for their
actions.
he product is intended for fastening and removing
screws and bolts.
Do not use the product in any way other than those stated
for intended use.
NOTE: It is recommended to use pilot holes prior to
driving screws.
WARNING
Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
DRILL AND SCREWDRIVER SAFETY WARNINGS
Hold power tool by insulated gripping surfaces
when performing an operation where the cutting
accessory may contact hidden wiring.
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
Hold power tool by insulated gripping surfaces
only when performing an operation where the
fastener may contact hidden wiring. Fasteners
contacting a "live" wire may make exposed metal parts
of the power tool "live" and could give the operator an
electric shock.
CHARGER SAFETY
Do not expose charger to wet or damp conditions.
Use of an attachment not recommended or sold by the
battery charger manufacturer may result in a risk of
fire, electric shock, or injuries to person.
o reduce risk of damage to charger body and
cord, pull by charger plug rather than cord when
disconnecting charger.
ake sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage
and stress.
An extension cord should not be used unless
PT DA SV FI NO RU
English
utting
PL CS HU RO LV LT
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock.
If extension cord must be used, make sure:
a. hat pins on plug of extension cord are the same
number, size and shape as those of plug on charger.
b. hat extension cord is properly wired and in good
electrical condition.
Do not operate charger with a damaged cord or plug,
which could cause shorting and electric shock. If
damaged, have the charger replaced by an authorised
serviceman.
Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way; take
it to a qualified serviceman.
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock or fire.
o reduce risk of electric shock, unplug the charger
from outlet before attempting any maintenance or
cleaning. urning off controls will not reduce this risk.
Disconnect charger from power supply when not in use.
Risk of electric shock. Do not touch uninsulated portion
of output connector or uninsulated battery terminal.
Save these instructions. Refer to them frequently and
use them to instruct others who may use this unit.
If you loan someone this unit, loan them these
instructions also.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. he following hazards may arise, and the operator
should pay special attention to avoid the following:
Damage to hearing caused by noise
Wear suitable hearing protection and limit exposure.
Injury to the eyes
Wear protective eye shields or goggles when using the
product.
Injury caused by vibration
Limit exposure. Follow the instructions in Risk
Reduction.
Electric shock caused by contact with hidden wires
Hold the product only by insulated services.
Injury caused by dust
Dust created by operating the product can cause
respiratory injury. Wear appropriate dust control mask
with filters suitable for protecting against particles from
the material being worked on.
1
ET HR SL SK EL TR UK