Omnitronic MCP-4150 Bedienungsanleitung Seite 25

5 Ground lift switch
Separates the ground connection between the inputs and
outputs
• position GND: ground connection established
• position LIFT: ground connection separated
6 Input jacks
XLR inputs for connecting units with line level.
7 Plug-in screw terminals
• contacts 1 to 3: alternative input, directly connected to
the respective XLR input; also suitable for feeding the
signal through to the input terminals of other channels
• contacts 4 and 5: speaker connections ("+" and "-" for
normal operation, "+" for bridge operation)
8 Selector switch operating mode
• switch engaged: bridge operation
• switch disengaged:normal operation
9 Level control
10
Selector switch for the filter type
• switch engaged:
• switch disengaged: high pass filter (HI PASS)
11 Selector switch for the filter
• switch engaged:
• switch disengaged: filter off (BYPASS)
12 Power input with fuse holder
• Used to plug in the supplied power cable.
• Only replace the fuse when the device is disconnected
from mains. Only use fuses of the same rating and
power. The correct fuse value is specified on the rear
panel.
13
Voltage selector switch
• left position: 115 V
• right position: 230 V (basic setting)
25/32
low pass filter (LOW PASS)
filter on (FILTER)
00052968.DOC, Version 1.2