Operation; Starting Position With Weather Data Display; Alarm And Error Messages - Elsner Ws1 Bedienungsanleitung

Operation

Starting position with weather data display

In the starting position, the control shows the current weather data on the
display. The individual display pages are automatically shown one after the
other in the default setting:
•
Outdoor temperature and indoor temperature
•
Light intensity, sun altitude and sun angle
•
"All channels are in automatic mode" or the numbers of output channels
that are in manual mode
•
"No wind alarm active" or the numbers of output channels that are locked
by wind alarm
•
Relative humidity indoors and wind force at the weather station.
Precipitation is indicated by the message "Rain" on this display page
•
If light intensity falls below 10 lux, "Twilight – night" is indicated on the
display pages with temperatures and humidity/wind
•
Date with week day and time are continuously indicated
If you would like to manually switch between the pages with the different values,
adjust the display mode from "automatic" to "manual", as described on p. 116.
Then switch the display page by pressing the ok key.

Alarm and error messages

In the starting position, various alarm and error messages may be displayed.
They appear within or instead of the weather data display pages. Possible
messages include:
•
"Please set clock!"
Is displayed instead of date and time. In case of DCF radio reception, the
clock will be set automatically after approx. 10 minutes. If DCF reception
should be insufficient, please set the clock manually (see chapter
"Adjustment of date and time", p. 86)
77