Operating Elements & Connections; Receiver - Omnitronic UHF-502 Bedienungsanleitung

4
OPERATING ELEMENTS & CONNECTIONS

Receiver

A Receiver unit A
B
Receiver unit B
1 Volume control for audio signal of the respective channel at the rear outputs.
2 LCD
3 Buttons ▲ and ▼ to manually select the transmission channel. By pressing both buttons
simultaneously the lock mode is enabled and disabled.
4
Infrared interface
5 Button AFS SET for automatic frequency scanning
6
Backlit power switch
7 Antenna input
8
Balanced, 3-pin XLR outputs for the output signal from the respective channel. For connection to
balanced microphone inputs of a mixer or amplifier.
9 Unbalanced output of the mixed signal of both channels (6.3 mm jack) for connection to a
microphone or line input of a mixer or amplifier.
10 Sliding switch for line or microphone level at the unbalanced audio output.
11 Sliding switch for adjusting the squelch threshold.
12 Power input; plug in the connection cable of the supplied power unit here.
17