Inhaltsverzeichnis
Werbung
Unit is in cleaning position,
valve block is not fitted
No basic unit identified
No piston fitted
Special cleaning position case:
If the basic unitis in cleaning position, mounting can be facilitated by moving the spindle slowly to the lower stop by pres-
sing the "Move" button in the message on the control unit for a longer period of time. If the spindle is already at the lowest
point, pressing the button for a longer period will move it slightly upwards again.
- Upper part of basic unit is turned
to the right-hand stop (dismantling
position)
- Upper part of basic unit has been
dismantled
- Basic unit not connected to control
unit
- Basic unit was assembled without
piston
- 71 -
- Turn the upper part slightly to the left
- Assemble basic unit again
- Check cable connection
- Dismantle basic unit and fit piston
again
Werbung
Inhaltsverzeichnis
