E) Adjusting The Slip Clutch - Reely NEW1 Bedienungsanleitung

e) Adjusting the Slip Clutch

The slip clutch protects the transmission from overload e.g. when starting on an especially non-slip surface.
The corresponding setting of the slip clutch also protects the vehicle from overturning as a result of the high torque of
the brushless drive when starting.
The manufacturer has already chosen the best setting; therefore, a change is usually not necessary.
Frequent start-up with full power on a ground with good grip, however, may cause wear to the slip clutch, which may
require adjustment of the slip clutch. Furthermore, professional drivers may adjust the slip clutch to match the desired
start-up behaviour on a specific ground.
If you want to change the setting, proceed as follows:
Pull out the two clips (A); then the dust protection cover
(B) can be taken off.
The slip clutch can be adjusted by twisting the hexagon
nut (C).
Turn is clockwise to the right to increase power transmis-
sion, turn it counter-clockwise to the left to reduce power
transmission.
If the slip clutch is tightened too much, the driv-
ing power will be fully transmitted and the slip
clutch is inactive. This may damage the differ-
ential; there also is the danger that the vehicle
turns over due to the high torque if the under-
ground friction is too high.
If the slip clutch is set too "soft", the slip clutch
wears very strongly. In addition, acceleration is
poor or the vehicle does not move at all (slip-
page of slip clutch).
Adjust the slip clutch in small steps only (max.
1/4 turn) and then test the vehicle's behav-
iour at start-up. Always remember the change
made, so that you can reverse it again if neces-
sary.
61