Inserting The Drive Battery In The Vehicle; F) Connecting The Drive Battery To The Speed Controller - Reely NEW1 Bedienungsanleitung

e) Inserting the Drive Battery in the Vehicle
Attention!
The drive battery must not be connected to the speed controller yet. First switch on the transmitter, see
chapter 9. d) and e).
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH drive battery with 6 or 7 cells (nominal voltage 7.2 V or 8.4 V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed control-
ler. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differential). Loss of
guarantee/warranty!
Check that the rechargeable battery has a plug system matching the speed controller and that the polarity
is right (red cable = plus/+, black cable = minus/-).
Remove the two hook-and-loop tapes (A) of the battery
holder.
Then insert the drive battery into the battery holder (B).
If the rechargeable battery has a very short connection
cable, the rechargeable battery must be inserted into the
rechargeable battery holder so that the connection cable
points forwards.
Pull the hook-and-loop tapes (A) tight so that the drive battery is seated firmly, and close the hook-and-loop tape.

f) Connecting the Drive Battery to the Speed Controller

Switch off the speed controller first (switch position "OFF").
The on/off switch is at the top of the chassis, right next to
the steering servo, see figure on the right.
Next to the on/off switch (A), there is the setup button (B)
that is used for programming (see chapter 10).
Then switch on the transmitter if you haven't done so yet
(see chapter 9. c) and d).
To prevent sudden start-up of the wheels and therefore uncontrolled starting of the model (e.g. if the trim-
ming for the drive is maladjusted), place the model vehicle on a suitable support (or starting box), so that
the wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable = mi-
nus/-). Do not apply any force when connecting the battery plug to the connection of the speed controller.
Make sure that the cables do not get into the drive of the vehicle or the steering mechanics. Use cable binders for
fastening if required.
46