j) Displaying Barometric Pressure Value for the Past 12 Hours
The weather station stores measured barometric pressure values of the last 12 hours.
To view the saved values, proceed as follows:
• Push the button „HISTORY" (D) briefly repeatedly. The lower left of the display then
shows the corresonding hours (-1 .... -12) and the associated barometric pressure.
• Wait for a few seconds without pushing any button. The current barometric pressure
is displayed again.
k) Set Altitude, Current Weather and Unit for Barometric Pressure
hPa/inHg
• Keep the button „HISTORY" (D) pushed for approx. 3 seconds to start setting mode.
• The display for the altitude of your place of residence flashes at the lower left of the
display. Set the altitude with the „+" and „-" buttons (e.g. 400 m). Keep the respective
button pressed for quick adjustment.
• Briefly push the button „HISTORY" (D). The graphic symbol for weather forecast will
flash. Select the current weather with the buttons „+" and „-".
• Briefly push the button „HISTORY" (D). The barometric pressure unit will flash. Use
the buttons „+" and „-" to choose between the unit „hPa" (hectopascal) and „inHg"
(inch mercury column).
• Briefly push the button „HISTORY" (D) to leave setting mode.
l) Weather Forecast
The weather station calculates a weather forecast for the next 12 - 24 hours from the
barometric pressure development of the last hours/days. The achievable accuracy is
at about 70%.
Note:
• If „sunny" is displayed at night, it means a starry night.
• The display does not indicate the current weather situation, but a forecast for the next
12 to 24 hours.
44