Commissioning; Outdoor Sensor; Weather Station - Renkforce AOL-5052B Bedienungsanleitung

8. Commissioning

First take the outdoor sensor into operation and then the weather station. For
correct calculation of the barometric pressure, the weather station needs to
know the approximate altitude of your place of residence. You can find it, e.g.,
on the website of your town or municipality.
a) Outdoor Sensor
• Open the battery compartment of the outdoor sensor by pulling the battery compartment
lid off downwards.
• Insert two type AAA/Micro batteries in the battery compartment in the correct polarity
(observe plus/+ and minus/-). The display of the outdoor sensor briefly shows all display
segments, and then the first measured value for tempertature and humidity.
• Select the transmission channel of the outdoor sensor by briefly pushing the button
„CH" in the battery compartment of the outdoor sensor. The display of the outdoor
sensor shows the current transmission channel („CH1" = channel 1, „CH2" = channel 2,
„CH3" = channel 3).
When operating only a single outdoor sensor, always set the channel to 1. If several
outdoor sensors are operated (up to 3 are possible), set a different channel for each
outdoor sensor.
• Briefly push the button „°C/°F" in the battery compartment of the outdoor sensor to
switch between the temperature unit °C (degrees Celsius) and °F (degrees Fahren-
heit).
• Close the battery compartment of the outdoor sensor again.
The LED above the LC display flashes briefly (approx. every 50 seconds) when
the outdoor sensor sends the measured values. The display of the outdoor
sensor briefly shows a radio tower symbol.
b) Weather Station
• Open the battery compartment on the back of the basis station.
• Insert two type AA/Mignon batteries in the battery compartment in the correct polarity
(observe plus/+ and minus/-).
• Close the battery compartment again.
• Right after inserting the batteries into the weather station, all display segments appear
briefly and a beep is emitted.
34