F) Selecting The Temperature Unit °C/°F; G) Switching The Outdoor Sensors - Renkforce AOL-5052B Bedienungsanleitung

Observe that the value set for the upper temperature limit must be higher than
the value for the lower temperature limit. Never swap the two values.
• Briefly push the button „MODE" (A). The temperature value for the upper temperature
limit flashes, and the symbol „ " appears above the time.
• Set the lower temperature limit with the buttons „+" and „-". Keep the respective
button pressed for quick adjustment.
• Briefly push the button „MODE" (A) to leave setting mode.
When the upper temperature limit is exceeded or the lower temperature limit is
undercut, the weather station will emit a signal. The asscoiated channel number
of the outdoor sensor is displayed and the symbol „ " for tempeature alarm
will flash.
Push any button to interrupt the sound signal.
f) Selecting the Temperature Unit °C/°F
• Briefly push the button „-" at the weather station to switch the temperature unit
between °C (degrees Celsius) and °F (degrees Fahrenheit).
• At the outdoor sensor, open the battery compartment and push the button „°C/°F" to
switch the temperature unit between °C (degrees Celsius) and °F (degrees Fahren-
heit).

g) Switching the Outdoor Sensors

• When more than one outdoor sensor is logged on to the weather station, briefly push
the button „CHANNEL" (E) to switch between the outdoor sensors and display their
measured values. The respective sensor/channel number (23) is displayed.
• If switching between the outdoor sensors is to take place automatically, push the
button „CHANNEL" (E) repeatedly until the symbol „
outdoor humidity.
The measured values of the outdoor sensors are displayed here in sequence for a few
seconds (and the associated sensor/channel number).
42
" appears to the left of the