Switching The Alarm Function On/Off; Activate Snooze Function Or Terminate Alarm; F) Selecting The Temperature Unit °C/°F - Renkforce 1267659 Bedienungsanleitung

Switching the Alarm Function On/Off

Repeatedly press the button „UP" briefly to activate or deactivate the alarm function.
The corresponding symbols appear above the seconds display:
Symbol „ ": Alarm function switched on with alarm time 1
1
Symbol „ ": Alarm function switched on with alarm time 2
2
Symbol „ ": Alarm functions with alarm times 1 and 2 on
1 2
No display: Alarm function off

Activate Snooze Function or Terminate Alarm

• The alarm signal is activated at the set alarm time and the bell symbol „
time 1) or „ " (for alarm time 2) flashes.
2
• Pushing the button „SNOOZE/LIGHT" (11) on the top of the weather station or the
button „SNOOZE" (9) will interrupt the alarm signal for 5 minutes. During this time, the
bell symbol continues to flash. „Z
Then the alarm signal is started again.
This procedure can be repeated several times.
• To terminate the alarm signal (or snooze mode), push another button than the two
buttons „SNOOZE/LIGHT" (11) and „SNOOZE" (9).
The alarm signal is automatically terminated after 2 minutes if no button is
pushed.
f) Selecting the Temperature Unit °C/°F
• Keep the button „MEM" (8) at the weather station pushed (approx. 3 seconds) to switch
the temperature unit between °C (degrees Celsius) and °F (degrees Fahrenheit).
• At the outdoor sensor, open the battery compartment and push the button „°C/°F"
(16) to switch the temperature unit between °C (degrees Celsius) and °F (degrees
Fahrenheit).
40
" also flashes to the left of the bell symbol.
Z
" (for alarm
1