Standard Accessories; Specifications - Hitachi SP 18VA Bedienungsanleitung

English
SAFETY WARNINGS SPECIFIC FOR
POLISHING OPERATIONS
a) Do not allow any loose portion of the polishing
bonnet or its attachment strings to spin freely. Tuck
away or trim any loose attachment strings.
Loose and spinning attachment strings can entangle
your fi ngers or snag on the workpiece.
PRECAUTIONS ON USING
ELECTRONIC SANDER POLISHER
1. Never mount a grinding wheel and attempt to use this
tool as a disc grinder.
2. Always hold the body handle and side handle of the
power tool fi rmly.
Otherwise the counterforce produced may result in
inaccurate and even dangerous operation.
3. Ensure that sparks resulting from use do not create
a hazard e. g. do not hit persons, or ignite fl ammable
substances.
4. Always use protective safety glasses and hearing
protectors, use other personal protective equipment
such as gloves, apron and helmet when necessary.
5. Always use eye and ear protection.
Other personal protective equipment such as dust
mask, gloves, helmet and apron should be worn when
necessary.
If in doubt, wear the protective equipment.
6. Mounting the sanding disc and wool bonnet.
○ Improper fi tting of the wool bonnet may cause vibration.
○ Use a wrench to tighten the washer nut suffi ciently.
○ After releasing the lock pin, check to be sure that it has
returned to its normal position.
7. RCD
The use of a residual current device with a rated residual
current of 30 mA or less at all times is recommended.
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
SP18VA: Electronic Sander Polisher
Read all safety warnings and all instructions.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
Alternating current
min Revolution or reciprocations per minute
-1
Switching ON
Switching OFF
Disconnect mains plug from electrical outlet
Warning
Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
(1) Rubber Pad .................................................................1
(2) Loop Handle (with bolt and washer) ............................1
(3) Bar Wrench .................................................................1
Standard accessories are subject to change without notice.
APPLICATIONS
○ Grinding metal surfaces
○ Preliminary sanding of metal surfaces before painting,
rust removal, removing old paint before repainting.
○ Finishing woodwork, correcting projections of timber
from joints or assemblies.
○ Preliminary sanding of wood surfaces before applying
paint.
○ Polishing or shining painted metal surfaces, such as
those of automobiles, trains, elevators, refrigerators,
sewing machines, washing machines, metal appliances,
etc.
○ Polishing varnished surfaces of wooden furniture, etc.
○ Shining synthetic resin or ebonite products.

SPECIFICATIONS

Voltage (by areas)*
Power input
No load speed
Rated Speed
Sanding Disc Size outer dia. ×
inner dia.
Weight (without cord, standard
accessories)
* Be sure to check the nameplate on product as it is subject
to change by areas.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
4
(110 V, 120 V, 220V,
230 V, 240 V)
1250 W*
0 – 3400 min
-1
3750 min
-1
180 × 22 mm
2.8 kg