Specifications; Standard Accessories; Battery Removal/Installation - Hitachi G 14DSL Bedienungsanleitung

Do not place electrically conductive cuttings, nails,
steel wire, copper wire or other wire in the storage
case.
Either install the battery in the power tool or
store by securely pressing into the battery cover
until the ventilation holes are concealed to prevent
short-circuits. (See Fig. 1)

SPECIFICATIONS

Cordless disc grinder
Model
Voltage
Rated speed
outer dia. × thickness × hole dia.
Wheel
peripheral speed
Rechargeable battery
Weight
Charger
Model
Charging voltage
Weight

STANDARD ACCESSORIES

1 Depressed center wheel ........ 1
2 Wrench ..................................... 1
3 Side handle ............................. 1
G14DSL
4 Charger ..................................... 1
G18DSL
5 Battery ...................................... 2
6 Plastic case .............................. 1
7 Battery cover ........................... 1
G14DSL (NN) Without charger, battery, plastic
G18DSL (NN) case and battery cover
Standard accessories are subject to change without
notice.
APPLICATIONS
Removal of casting fin and finishing of various
types of steel, bronze and aluminum materials and
castings.
Grinding of welded sections or sections cut by
means of a cutting torch.
Grinding of synthetic resins, slate, brick, marble, etc.
Cutting of synthetic concrete, stone, brick, marble,
and similar materials.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (See Fig. 1 and 2).
CAUTION
Never short-circuit the battery.
BSL1430:
Li-ion 14.4 V
(3.0 Ah, 8 cells)
UC18YRSL UC18YFSL
14.4 V – 18 V
0.6 kg 0.5 kg
G14DSL
14.4 V
-1
9300 min
115 × 6 × 22.23 mm
80 m/s
BSL1440: BSL1450:
Li-ion 14.4 V Li-ion 14.4 V
(4.0 Ah, 8 cells) (5.0 Ah, 8 cells) (3.0 Ah, 10 cells) (4.0 Ah, 10 cells) (5.0 Ah, 10 cells)
1.7 kg
2. Battery installation
Insert the battery while observing its polarities (See
Fig. 2).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger, as shown
in Figs. 3, 4.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
English
G18DSL
18 V
-1
9100 min
BSL1830: BSL1840:
Li-ion 18V Li-ion 18V
1.8 kg
BSL1850:
Li-ion 18V
10