Operation - EuroLite LED Disco Strobe COB Bedienungsanleitung

The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
The device has to be installed out of the reach of people.
The device must never be fixed swinging freely in the room.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
The device must be installed in an absolutely horizontal position.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!

OPERATION

After you connected the effect to the mains, the LEDs of the LED Strobe light up briefly.
The device has two operating modes. By turning the Sound/Auto dial, you can switch between operating
modes.
Auto mode:
Turn the dial to the left until you hear a click.
Flash rate can be set via the „Speed" dial.
Sound mode:
Turn the dial to the right until you hear a click.
Additionally, microphone sensitivity can be set via the Sound/Auto dial. By turning the Sound/Auto dial from
the Sound mode starting position to the right, microphone sensitivity – increasing – can be ajusted.
Flash rate can be set via the „Speed" dial.
For item no. 52200656, RGB colored flashes, each color four times, seven colored mixture.
1416 00101579.DOC, Version 1.0