Beurer BC 60 Gebrauchsanweisung Seite 22

: lack of haemodynamic stability
It is very probable that the measurement of systolic and
diastolic blood pressure has not been carried out at rest and
has therefore distorted the measurement.
Repeat the measurement after a rest and relaxation period
of at least 5 minutes. Go to a sufficiently calm and comfort-
able spot and remain there calmly; close your eyes, breathe
deeply and evenly and try to relax.
If the following measurement shows a lack of stability again,
repeat the measurement after another period of rest. In case
of further unstable measurements, identify these measure-
ments as they were taken when the circulatory system had
not be sufficiently rested.
In this case, inner unrest of the nervous system could be
the cause, which cannot be cured by brief periods of rest.
Developing cardiac arrhythmia can also prevent stable
blood pressure measurements.
A lack of resting blood pressure can have various causes,
such as physical or mental strain or distraction and speak-
ing or experiencing heart rhythmic disturbance during the
measurement.
In an overwhelming number of cases, the HSD diagno-
sis will give a very good guide as to whether the circula-
tory system is rested when taking the measurement. Certain
patients suffering from cardiac arrhythmia or chronic men-
tal conditions can remain haemodynamically unstable in the
long-term, something which persists even after repeated
periods of rest. The precision of the results of the resting
blood pressure is reduced in these users. Like any medical
measurement method, the precision of the HSD diagnosis is
limited and can lead to incorrect results in some cases. The
blood pressure measurements taken when the circulatory
system was at rest represent particularly reliable results.
6. Calling up stored values
You can call up values from the 2 user memories and dis-
play the averages.
• Press the M1 or M2 memory buttons. Firstly, the average
of all values stored in this user memory will be displayed.
This is denoted by the letter in the display.
• If you press the memory buttons again, further individual
measurements appear with WHO, cardiac arrythmia and
HSD. These individual values are numbered from 1 to 60.
The time and date are alternately displayed after 2.5 sec-
onds.
• If there are 60 individual values in the memory at the same
time, the oldest value is deleted in order to make room for
the new value.
• Use the start/stop button
will turn off automatically after approx. 30 seconds.
Tip: You can also use the 2 user memories to separately
store measurements – e.g. mornings and evenings.
22
to turn off the device, or it