Inhaltsverzeichnis
Werbung
MAINTENANCE
Make sure that the machine is kept in top shape by following the maintenance schedule closely. Maintenance intervals given are for average operating conditions.
Machines used in severe environments may require service more often.
Repairs, when required, should be performed by your Authorized Nilfisk Service Center, who employs factory trained service personnel and maintains an inventory
of Nilfisk Original Equipment Replacement Parts and Accessories.
MAINTENANCE SCHEDULE
Check Foot/ Parking Brake For Wear & Adjustment
* Have your Nilfisk Dealer check the carbon motor brushes once a year or after 300 operating hours.
NOTE: Refer to the Service Manual (form number 56043048) for more detail on maintenance and service repairs.
EVERY 30 HOURS OF OPERATION
1
Rotate the Main Broom. Refer to the Main Broom Maintenance section.
2
Adjust the Main Broom. Refer to the Main Broom Maintenance section.
3
Clean the Hopper Dust Control Filter (20) using Method "A". Refer to the Hopper Dust Control Filter section.
4
Adjust the Side Broom. Refer to the Side Broom Maintenance section.
EVERY 150 HOURS OF OPERATION
1
Clean the Hopper Dust Control Filter (20) using Method "B". Refer to the Hopper Dust Control Filter section.
2
Lubricate all Grease Fittings.
Grease fitting locations are:
*
(4) on steering sprockets
*
(1) on steering u-joint
*
(2) on drive wheel gearcase spindle
EVERY 300 HOURS OF OPERATION
1
IMPORTANT! Change the gear lube in the drive wheel gearcase after the first 300 hours of operation.
2
Clean the Hopper Dust Control Filter (20) using Method "C". Refer to the Hopper Dust Control Filter section.
32 - FORM NO. 56041420 / SR 1600
MAINTENANCE ITEM
Charge Batteries
Check Battery Water Level(s)
Inspect Broom Housing Skirts
Inspect Main Broom Upper and Lower Belts
Steering Chain Tension
Lubrication - Grease Fittings
Check Hydraulic Fluid
Replace Hydraulic Filter
* Check Carbon Brushes
Daily
Weekly
Monthly
•
•
•
•
Yearly
•
•
•
•
•
•
Werbung
Inhaltsverzeichnis
Fehlerbehebung
