Joie Stages C0925 Bedienungsanleitung Seite 13

!
Shoulder belt must pass through shoulder belt
- 1
guide. 34
!
Waist belt must pass through seat slots. 35 - 1
! The vehicle buckle tongue is engaged with the
buckle correctly shown in. 35 - 2
!
The child restraint cannot be used if the vehicle
safety belt buckle (female buckle end) is too long
to anchor the child restraint securely. 35 - 3
23
34
1
2
35
3
2
1
36
1
3
!
Never use a 2-point vehicle belt across front of child.
!
Do not use vehicle shoulder belt loose or positioned under child's arm.
!
Do not use vehicle shoulder belt behind child's back.
! Do not allow child to slide down in the child restraint.
Soft Goods Assembly
1. Remove the infant insert and crotch pad.
2. To remove the shoulder pads﹐ first unsnap the pads then
remove the webbing attached by the velcro.
37
3. Press the red button down to disengage the buckle.
- 2
4. Detach hook and loop fasteners 31 on the head support
from slots in vehicle shoulder belt guides﹐ and then remove
the head support cover.
- 1
5. Detach the snaps on sides of seat pad. 31
6. Detach elastic tabs﹐ located behind head support﹐ from the
seat shell.
7. Detach the fabric attachment piece from the upper rear of
seat shell.
8. Pull the buckle through the slot in the seat pad and then
remove seat pad from seat shell.
The soft goods can be re-assembled by reversing the above steps.
!
Please reference images 30-32 (Converting from Toddler Mode to Youth Mode) for proper routing of harness
through seat pad.
2
4
- 1
36
- 2
36
- 3
36
- 4
36
37
18
24