Joie Stages C0925 Bedienungsanleitung Seite 11

26
27
4. Open the lock-off device and insert the shoulder safety belt.
!
Please check if the child restraint is installed tightly by moving the child restraint back and forth at the
vehicle belt path. (child restraint should not move more than 25mm/1").
.
The assembled vehicle belt is shown in 27
!
Vehicle Shoulder belt passes through Lock-off Device.
!
Vehicle Waist belt passes through the forward-facing vehicle belt slots.
!
The vehicle buckle tongue is engaged with the buckle correctly shown in.
19
1
2
3
26
- 1
27
- 2
27
- 3
27
ii. Securing your Child in the Child restraint
see images -
28 29
Note
1. When installing the child restraint in the forward-facing Toddler mode, do not use the infant insert.
2. Please install the child restraint on the vehicle seat, and then place the child in the child restraint.
3. After the child is placed into the child restraint, double check whether the shoulder harness straps are at
the proper height. Please refer to images 6-7
Straps).
- 1
1. Pull up the webbing lock 17 ﹐ while pulling
the shoulder harness straps to proper length.
- 2
17
2. Press the red button down to disengage the
buckle. 18
3. Leave the harness straps on the left and right
sides of the child restraint.
28
4. Place the child in the child restraint and engage
the buckle. 21
!
After the child is seated﹐ double check
whether the shoulder harness straps are at
the proper height. Please refer to images 6-7
(Height Adjustment for Head Support and
Shoulder Harness Straps).
5. Pull down the adjustment webbing and adjust
the harness so that your child is snugly secured.
29
!
Make sure the space between the child and
the shoulder harness straps is about the
thickness of one hand. 29
(Height Adjustment for Head Support and Shoulder Harness
28
29
20