Assembly Instructions - Ferm TSM1031 Übersetzung Der Originalbetriebsanleitung

EN
35. Avoid workpieces hitting back in your direction
by taking the following measures:
• Always use sharp saw blades.
• Do not saw too small workpieces.
• Never release the workpiece before it has
been completely pushed through the saw.
• Always adjust the guide parallel to the
saw blade.
• Never remove the saw protection.
36. Before you continue sawing, ensure that you
are standing firmly and that your hands are in
the required position.
37. Never use thinners to clean the machine. Only
use a damp cloth for cleaning.
38. Do not use saw blades which are damaged or
deformed.
39. Replace table insert when worn.
40. Use only saw blades recommended by the
manufacturer.
41. Take care that the selection of the saw blade
depends on the material to be cut.
42. Connect circular saws to a dust-collecting
device when sawing.
43. Use and correct adjustment of the riving knife
44. Use and correct adjustment of the upper saw
blade quard.
45. Take care when slotting.
Before use, remove the transport protection:
• Disassemble the bottom plate by loosening
the 4 screws.
• Remove the transport protection below motor.
• The handles for height and mitre setting of the
saw blade are located in the transport
protection inside the machine.
• Reassemble the bottom plate.
Switch off the machine immediately when you
discover:
• A defective mains plug or mains lead.
• A defective switch.
• Overheating of the machine.
• Smoke or odeur caused by scorched
insulation.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
8
Always check that the power supply
corresponds to the voltage on the rating
plate.
Replacing cables or plugs
Immediately throw away old cables or plugs when
they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
• As a supply for this machine always use an
unloaded line and/or an extension cable with
conductors of at least 1,5 mm
with a 16 A fuse. Be sure that this extension
cable is not longer than 20 metres.
• Only connect your machine and/or extension
cable to an earthed electricity mains.
• This machine can be switched to the single-
phase network (230 V/50 Hz). If you are in
doubt about the earth of the electricity
provisions, consult an electrician first.

3. Assembly instructions

Assembly of the bench extensions
Fig. F
• Before attaching the bench extensions, first
remove the perforated base plate (you can
now also remove and discard the motor
protection materials).
• Once the bottom side is open, you can attach
the diagonal support struts to the bench saw.
• Now attach the bench extensions to the basic
bench top. Next, attach the extensions to the
diagonal support struts.
• Once all the extensions have been
assembled, re-attach the base plate (taking
care that all extensions are perfectly lined up
with the basic bench top itself).
• Lastly, attach the guide rail (with ruler) to the
front edge of the bench top.
Installation of the machine on a workbench or
on the subframe
This machine is a stationary machine and for
safety reasons must always be firmly installed and
not used for mobile applications.
You can install the machine in two ways:
a. As a stationary machine on a workbench. In
this case the machine must be secured to the
workbench with 4 bolts.
and protected
2