Werbung
GB
•
Do not touch the bit or parts close to the bit immediately after operation; they may be
extremely hot and could burn your skin.
When chipping into walls, floors or wherever "live" electrical wire may be
encountered, do not touch any metal parts of the tool!
Electrical safety
Always check that the mains voltage is the same as on the type plate of the
machine.
Replacement of power cords or plugs
Immediately dispose of old cords and plugs once they have been replaced. It is dange-
rous to plug a loose power cord into a mains power socket.
Use of extension leads
Only ever use approved extension leads that are suitable for the power rating of the
machine. The minimum core thickness is 1.5 mm
always fully unroll the lead.
3. ASSEMBLY
Mounting tool bits
Fig. 3
Before exchanging a bit, first remove the power plug from the mains.
•
Lightly oil the bit shaft before inserting it into the tool holder.
•
Rotate the stop lever 180º clockwise, while pulling it towards you
•
Insert the tool shank into the hexagonal tool holder: the flat side of the bit towards the
side of the stop lever.
•
Rotate the stop lever 180º counterclockwise to lock the bit.
Auxiliary handle
Fig.2
The auxiliary handle can be adjusted to several positions to have a good control to the
tool.
4. OPERATION
Before operation: Ensure the power switch is in OFF position. If the plug is
connected to the mains while the switch is in ON position the machine will start
immediately, which could cause serious injury.
06
2
. Whenever using a reel extension lead,
Ferm
Ferm
DK
75
Quicklinks ausblenden:
Werbung
Kapitel
