Transport; Storage; Care And Maintenance; Troubleshooting - Kärcher SGG 1 Originalbetriebsanleitung

Cleaning operations
Note: Clean a small test area before per-
forming the actual cleaning process in or-
der to check that the surface will not be
damaged.
Note: Do not scrub while cleaning and do
not exert pressure on the surface being
cleaned because the own weight of the
lance is sufficient.
 Place the lance on the surface to be
cleaned and wait 2-3 seconds.
 Work on the chewing gum residue with
circular movements of the brush until it
dissolves.
 Brush over the surface with a broom
and check that the chewing gum resi-
due has been completely removed.
 Repeat the cleaning process if neces-
sary.
Turn off the appliance
 Switch off the device at the on/off
switch.
 Allow the lance to cool down for 3 min-
utes before setting it down.
 Park the machine on an even surface.
After each operation
DANGER
Risk of burns! Warning of hot exhaust man-
ifold.
The hoses and lines of the device must be
emptied after every period of operation.
Note: When emptying the device, take care
that no surfaces are damaged by the deter-
gent.
 Press in the latches at both sides and
remove the device cover.
 Turn both gas valves on the valve tube
clockwise to close off the gas supply.
 Remove the gas cartridges from the
casing and unscrew anticlockwise from
the valve tube.
 Screw on the special cover of the deter-
gent tank and remove the detergent
tank from the casing.
 Switch on the device at the on/off
switch.
18
 Set the detergent supply regulator to 10
and wait until no more liquid escapes
from the nozzle on the lance.
 Switch off the device at the on/off
switch.
 Disconnect the control unit from the de-
vice.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
Store the device only in dry, adequately
ventilated spaces.

Care and maintenance

DANGER
Switch off the device prior to all work on the
device.
Replace the seal on the valve tube
 Press in the latches at both sides and
remove the device cover.
 Pull out the valve tube.
 Carefully lever out the seal on the valve
tube using a screwdriver. Take care to
ensure that the gas cartridge threads
are not damaged.
 Insert a new seal.
Maintenance intervals
Yearly
 Have the maintenance of the device
performed by the customer service.

Troubleshooting

DANGER
Switch off the device prior to all work on the
device.
– 6
EN

Transport

Storage