Cleaning
RISK OF ELECTRIC SHOCK!
Before starting to clean the blender and its components:
►
Ensure that the motor is switched off and the power plug removed from the
socket.
►
Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
►
Never disassemble the cutting blades
The cutting blades
CAUTION – PROPERTY DAMAGE!
►
Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
Cleaning the blender
■
To prevent injuring yourself on the cutting blades
with a long-handled washing-up brush.
■
In a case of stubborn soiling, the blender
washer. To do this, always remove the blender
■
Clean the lid
normal washing up.
If you clean the blender directly after use, you can often achieve a satisfacto-
ry and hygienic level of cleaning by doing the following:
Fill the blender
detergent. Close the lid
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades
at full speed.
Afterwards, rinse out the blender
all detergent residues have been removed.
■
12
│
GB
Do not immerse the motor block
could result in you receiving a fatal electric shock and cause damage
to the appliance.
are extremely sharp!
and the measuring cap
with 750 ml of water and add a few drops of mild
and fit the blender
in water or other liquids. This
and never reach into the blender
, clean the blender
can also be cleaned in a dish-
, as described later.
in a dishwasher or with the
onto the motor block
churn through the water
with lots of clean water to ensure that
.
only
.
SSM 550 D1