Unpacking; Setting Up; Operation - Silvercrest IAN 281321 Bedienungsanleitung

Unpacking

■ Remove all packaging materials or protective films from the appliance. Retain
the packaging, so that you can store the appliance safely or send it by post,
e.g. if it needs to be repaired.
■ Before using the appliance, check that it is free of damage; check also that
the power cable and plug as well as all accessories and appliance parts are
undamaged.
■ Clean all components carefully before using the appliance for the first time
(see "Cleaning").

Setting up

Once all components have been cleaned as described in the section "Cleaning":
■ Position the appliance so that, ...
–
that the mains cable
appliance,
–
the power plug is immediately accessible, so that it can be quickly
withdrawn in the event of danger,
–
that it is stable and not liable to slip, and so that the sucker feet can
attach firmly and the appliance cannot tip over due to vibration,
–
that the mains cable
a risk of being inadvertently snagged and tipping the appliance over.

Operation

WARNING!
► The motor switches itself off as soon as the blender
motor block
is still switched on. The motor will then start unexpectedly as soon as the
blender
Therefore:
–
Do not insert the power plug into the wall socket until the blender
filled and mounted with its lid fitted and closed.
–
Before fitting the blender, always check to see that the appliance is
switched off or that the power plug has been removed.
–
Before removing the blender
power plug and wait for the motor to stop turning.
■ 6 │
GB
passes through the recess at the rear of the
is not in the working area and thus does not present
. It is thus possible to overlook the fact that the appliance
is replaced on it:
is removed from the
, switch the appliance off, remove the
is
SSM 550 D1