Safety Instructions; Safety Rules For Laser Lights - Kawasaki 603.010.030 Originalbetriebsanleitung

16. Bevel lock
17. Bevel scale
18. 0° Bevel adjuster
19. Fence
19 A/19B Fence
20. 4 mmHex key
21. Mitre table
22. Mitre scale pointer
23. Table insert (kerf plate)
24. Switch trigger
25. Mitre lock
25A Locking button
26. Spindle lock
27. Dust extraction port
28. Slide bars
29. Slide lock
30. Trenching depth adjustment screw
31. Trenching stop
32. Trenching depth lock nut
33. 45° Bevel adjustment screw (left)
34. 45° Bevel adjustment screw (right)
35. 0° Bevel adjustment screw
36. Side support bars (x2)
37. Side support bar location holes (2 sets)
38. Side support bar stop screws (inside)
39. Stabilizer bar
40. Flange wrench
41. Side support bar locking knob (x 2)
42. Saw blade
43. Ready indicator
44. Working light
45. Release latch

Safety rules for laser lights

NICHT IN DEN STRAHL BLICKEN
WARNING. Do not stare directly at the laser
beam.
WARNING. Itmay bemore difficult to see the
LASERSTAHLUNG
LASER KLASSE 2
P<1mW 650 nm
EN 60825-1:2007
25
laser line in conditions of bright sunshine and on
certain surfaces
A hazardmay exist if you deliberately stare into
the beam, please observe all safety rules as
follows;
The laser shall be used andmaintained in
accordance with themanufacturer's instructions.
Never aimthe beamat any person or an object
other than the workpiece.
The laser beamshall not be deliberately aimed
at personnel and shall be prevented from being
directed towards the eye of a person for longer
than 0.25s.
Always ensure the laser beamis aimed at a sturdy
workpiece without reflective surfaces. I.e.wood or
rough coated surfaces are acceptable.
Bright reflective sheet steel or the like is not
suitable for laser use as the reflective surface
could direct the beamback at the operator.
Do not change the laser light assembly with a
different type. Repairsmust be carried out by
the lasermanufacturer or an authorized agent.
CAUTION. Use of controls or adjustments or
performance of procedures other than those
specified hereinmay result in hazardous radiation
exposure. The use of optical instruments with this
product will increase eye hazard.

1. SAFETY INSTRUCTIONS

WARNING! When using electric tools. Basic safety
precautions should always be followed to reduce
the risk of fire, electric shock and personal injury.
Including the following.
Read these instructions before operating this
product and save these instructions.
1. keep work area clean
- Cluttered areas and benches invite injuries.
2. Consider work area environment
- Do not expose power tools to rain. Do not use
power tools in damp or wet locations. Keep work
area well lit. Do not use power tools where there
GB