Maintenance And Care - Miele CarClean Set Plus Gebrauchsanweisung

Important note for Miele vacuum
cleaner model S 5980 / S 5981
^ Connect the CarClean Set Plus
suction hose as described above.
^ Switch the vacuum cleaner on using
the On/Off foot control s.
^ Press the Reset button.
The vacuum cleaner will switch on. It
can only be used at maximum power.
Hose tidy
The hose clip e can be used for
hanging the hose up (illustration n). It
is supplied with screws and rawl plugs
for securing it to a wall.
Using the hand-held
Turbobrush o
The hand-held Turbobrush is suitable
for vacuuming car seats and carpets. It
can also be used in the home for stairs
and other areas inaccessible with a
standard Turbobrush.

Maintenance and care

,
Always disconnect the vacuum
cleaner from the electrical supply for
cleaning or maintenance work on
the hand-held Turbobrush. Switch
off at the wall socket and remove the
plug.
Removing threads and hairs
(illustration p)
^ Cut any threads or hairs that have
become entangled on the brush roller
with a pair of scissors. Then run the
vacuum cleaner to vacuum up the
bits.
For more obstinate tangles or blockages
inside the hand-held Turbobrush, the
cover can be opened. Any large
particles inside it can then be easily
removed.
^ Turn the grip so that the release
button is in the middle of the guide
(illustration q - a).
^ Press the release button (illustration
q - b), and pull the grip out from the
hand-held Turbobrush as far as
possible (illustration q - c).
^ Lift the upper part of the casing as far
as it will go (iIlustration r), and
remove any debris from the inside of
the casing and from the brush roller.
^ Close the casing, and push the grip
back into position until it clicks into
place over the release button.
en
13