Stihl Autocut C 4-2 Mowing Head; Adjusting Trimmer For User; Adjusting The Loop Handle - Stihl FSA 65 Gebrauchsanleitung

8 Adjusting Trimmer for User

1
2
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3).
The deflector must not be removed again.
7.2

STIHL AutoCut C 4-2 Mowing Head

7.2.1 Mounting the Mowing Head
► Switch off the trimmer, push retaining latch to position
and remove the battery.
1
2
► Fit the mounting head (1) on the shaft (2).
► Rotate the spool (4) until the arrow heads on the spool and
mowing head (1) are in alignment.
0458-284-9921-A
3
2
3
4
1
► Fit the cap (3) in the spool (4) and tighten it down firmly by
hand (clockwise).
7.2.2 Removing the Mowing Head
► Switch off the trimmer and remove the battery.
► Hold the mowing head (2) steady and rotate the cap (1)
counterclockwise until it can be removed.
► Remove the cap (1) and mowing head (2).
8 Adjusting Trimmer for User
8.1

Adjusting the Loop Handle

The loop handle can be set to different positions to suit the
height and reach of the user.
► Switch off the trimmer, push retaining latch to position
and remove the battery.
English
1
2
35