Vacuum Packing Process Description - Hendi 975350 Gebrauchsanweisung

The manufacturer and dealer is not liable for any
inaccuracies due to printing errors or transcrip-
tion, in this manual. In line with our policy of con-
tinuous improvement products, we reserve the

4. VACUUM PACKING PROCESS DESCRIPTION

4.1 PRIOR TO START-UP
• Connect the machine to the power supply.
• When the machine is switched on, the LED lights up.
• The machine is ready to use.
4.2 HOW TO MAKE BAG FROM ROLL
• Choose roll with suitable width.
• Put the open end of the roll across the seal wire
(please make sure the open end is across the
seal wire); close the lid.
• While pressing lid down with thumbs, press in
latches on both sides of machine base with index
fi ngers and lock.
• Choose the right seal time option.
- "Normal" – Suitable for working in warm or hot
air temperature; or vacuum dry items (without
liquid).
- "Extended" – Suitable for working in cool or cold
air temperature; or vacuum wet items (with liquid).
4.3 HOW TO VACUUM AND SEAL WITH BAGS
• Choose suitable vacuum bag, place item in bag.
• Allow at least 4.5cm space after item is put in
bag, to ensure better vacuum.
• Put the open end of bag across the chamber seal
gasket. Please make sure that the open end is
within the vacuum chamber.
• Close the lid.
• While pressing lid down with thumbs, press in
latches on both sides of machine base with index
fi ngers and lock.
• Choose the right seal time option.
- "Normal" – Suitable for working in warm or hot air
temperature; or vacuum dry items (without liquid).
right to make modification of the product, pack-
aging and specifications contained in the Docu-
mentation without prior notice.
• Press "Seal" button. The machine starts to seal;
vacuum pump stops working; no noise; indicator
light turns to orange. When sealing is complete,
the machine will go on vacuuming for 3 seconds
to make vacuum more perfect; indicator light
turns to red.
• Lid will raise slightly and green light will illumi-
nate.
• Sealing cycle is complete.
• Remove bag and inspect seal. (Note: A positive
seal will look clear upon inspection. If the seal
is spotty, incomplete, wrinkled, white or milky,
remove sealed portion and run vacuum and
seal process again.)
- "Extended" – Suitable for working in cool or cold
air temperature; or vacuum wet items (with liquid).
• Press "Vacuum & Seal" button. Indicator light
will turn red.
• Vacuum pump will engage and suction will pull
lid and seal bar down causing lid to unlock (pop-
ping sound indicates latches unlocking).
• Vacuum level sensor knows when it achieves
proper vacuum level and will automatically go
into seal mode.
• When in seal mode, indicator light will change
orange, The machine starts to seal; vacuum
pump stops working; no noise; indicator light
turns to orange.
EN
7