Setting The Clock - PERFECTPRO WORKMAN Bedienungsanleitung

SETTING THE CLOCK

The clock can only be set when the radio is in standby mode. If no buttons are pressed
for 5 seconds, the radio will exit the clock setup and the setting is cancelled.
1. Press and hold the Tuning Control knob for 12 seconds until the hour digits flash on
the display.
2. Rotate the Tuning Control knob to set the hour.
3. Press the Tuning Control knob, the minute digits flash.
4. Rotate the Tuning Control knob to set the minute.
5. Press the Tuning Control knob to confirm, the day flashes on the display.
6. Rotate the Tuning Control knob to set the current day.
7. Press the Tuning Control knob to confirm, the month flash.
8. Rotate the Tuning Control knob to set the current month.
9. Press the Tuning Control knob to confirm, the year will then flash on the display.
10. Rotate the Tuning Control knob to set the current year.
11. Press the Tuning Control knob to confirm, "SYNCLOCK ON" flashes.
12. Rotary the Tuning Control knob to select "SYNCLOCK ON" or "SYNCLOCK OFF".
13. Press the Tuning Control knob to confirm and finish the clock setting.
RDS time synchronisation
If "SYNCLOCK ON" is selected, the symbol "
Some RDS stations transmit a time signal. If reception is good you have selected
the "SYNCLOCK ON" option during the time setting, the time will be automatically
updated (" " flashes on the display). Time synchronisation can take several
minutes. The automatic time setting is always activated when the radio is switched
from standby to FM broadcasting and receives a RDS station.
" will show on the display.
GB
G B
6