Original Accessories/Additional Equipment; Initial Operation; Additional Handle; Depth Stop - Parkside PBH 1500 C3 Originalbetriebsanleitung

service line detector before
GB
IE
you start to cut or drill into
a surface.
Original accessories/
additional equipment
Only use the
accessories and
additional equipment
that are specified in the
operating instructions
and are compatible with
the appliance.
24

Initial operation

Additional handle

NOTE
►For safety reasons, you should only use
this appliance with the additional handle
attached.
Remove the additional handle
turning it counter-clockwise direction.
Turn the additional handle
desired position.
Fix the additional handle
position by turning it clockwise.

Depth stop

Open the wing screw
Insert the depth stop
handle .
Ensure that the toothing on the depth stop
is facing upwards.
Pull the depth stop
for the distance between the tip of the
drill and the tip of the depth stop to
correspond with the required drilling
depth.
Re-tighten the wing screw
Tool/chuck:
Pull the locking collar
insert the tool/chuck
.
Release the locking collar
the holder. Check that the tool is properly
locked by pulling it. The system has radial
play because of the design.
Removing tool/chuck:
Pull the locking collar
backwards.
Remove the tool/chuck.
by
to the
in the new
.
into the additional
out far enough
afterwards.
backwards and
in the tool holder
. This locks
on the tool
PBH 1500 C3