Appliance-Specifi C Safety Instructions For Hammer Drills; Original Accessories/Additional Equipment; Initial Operation; Additional Handle - Parkside PBH 1500 A1 Betriebsanleitung

Appliance-specifi c safety instructions
for hammer drills
■ Wear ear protectors. Exposure to
noise can cause hearing loss.
■ Use auxiliary handle(s), if supplied with the
tool. Loss of control can cause personal injury.
■ Hold power tool by insulated gripping surfac-
es, when performing an operation where the
cutting accessory may contact hidden wiring
or its own cord. Cutting accessory contacting
a "live" wire may make exposed metal parts of
the power tool "live" and could give the opera-
tor an electric shock.
■ Wear a dust mask.
WARNING! TOXIC DUST!
► Working with harmful/toxic dusts results in
health hazards for the person operating the
appliance and for other persons in the area.
■
ATTENTION – SERVICE LINES! DANGER!
Take steps to ensure that you do not hit any
service lines (electricity, gas, water) when
working with the electric tool. If necessary,
check with a service line detector before you
start to cut or drill into a surface.
Original accessories/additional
equipment
■ Only use the accessories and additional
equipment that are specifi ed in the operat-
ing instructions and are compatible with the
appliance.

Initial operation

Additional handle

NOTE
► For safety reasons, you should only use this
appliance with the additional handle
attached.
♦ Remove the additional handle
clockwise direction.
♦ Turn the additional handle
position.
PBH 1500 A1
♦

Depth stop

♦
♦
♦
♦
♦
Tool/chuck:
♦
♦
Removing tool/chuck:
♦
NOTE
Tighten the drill in the wheel-rim chuck
same time. To do this, apply the chuck key to all
the 3 positions on the wheel-rim chuck
tighten the tool (e.g. drill) at the same time.
►
by turning it
to the desired
Fix the additional handle
by turning it anti- clockwise.
Open the wing screw
Insert the depth stop
handle .
Ensure that the toothing on the depth stop
facing upwards.
Pull the depth stop out far enough for the
distance between the tip of the drill and the tip
of the depth stop to correspond with the
required drilling depth.
Re-tighten the wing screw
Pull the locking sleeve
the tool/chuck in the tool holder
Release the locking sleeve
holder. Check that the tool is properly locked by
pulling it. The system has radial play because of
the design.
Pull the locking collar
WARNING!
Do not use the wheel-rim chuck
mer drilling or chiselling!
in the new position
.
into the additional
is
afterwards.
backwards and insert
.
. This locks the
on the tool backwards.
at the
and
for ham-
5
GB
IE
CY