F) Selection Of The Temperature Sensor; G) Frost Alarm; H) Displaying And Deleting The Max. And Min. Temperature Values - Renkforce 1423362 Bedienungsanleitung

f) Selection of the temperature sensor

• If necessary, adjust the unit for the temperature display first.
For this, push the slider B16 either to the position °C to display the temperature in °C
or to °F.
• Briefly push the button "CH +" (B4), to switch between the three channels for the
outdoor sensors. The standard channel is 1.
To the left of the display for the measured values of the outdoor sensor (C8),
the respective active channel number (C7) will appear.
• To automatically display all three channels for approx. 3 seconds in sequence, keep
the button "CH +" (B4) pushed for approx. 3 seconds. When the display of the channel
number (C7) switches to the next channel, release the button again.
• The reception level is displayed using the bar chart C5. If no bars are displayed, the
sensor has either not been found or the connection has been interrupted.

g) Frost Alarm

• If the outdoor temperature drops to below 3 °C to -2 °C, the display will indicate the
frost alarm(C6) and flash evenly.
• The symbol will disappear again once the temperature climbs over 3 °C or drops
below -2 °C.

h) Displaying and deleting the max. and min. temperature values

• Briefly push the button "MEM -" (B6) to display the stored maximum and minimum
temperature values in sequence. At the top of the display, you will see whether it is
the minimum value "MIN" or the maximum value "MAX". The order is:
Max. outdoor temperature; min. outdoor temperature; max. indoor temperature; min.
indoor temperature
• While looking at the individual maximum and minimum values, keep the button "MEM -"
(B6) pushed for approx. 3 seconds to delete the respective value.
50