Resetting To The Factory Settings; Outdoor Sensor; B) Projection Radio Alarm Clock - Renkforce 1423362 Bedienungsanleitung

11. Resetting to the factory settings

a) Outdoor sensor
Proceed as follows to reset the outdoor sensor to factory settings.
• Push the recessed button "RESET" (D3), for approx. 5 seconds, e.g. with a ballpoint
pen. The button is located at the rear of the sensor, below the battery compartment
lid.
• The system is now reset to factory settings.
Alternatively, you can also simply remove the batteries. Wait for at least
10 seconds before re-inserting them.

b) Projection radio alarm clock

Proceed as follows to reset the projection radio alarm clock to factory settings.
• Push the recessed button "RESET" (B13), e.g. with a ballpoint pen. The button is lo-
cated at the rear of the product.
• Release the button again when the display goes out.
• The alarm clock will emit a brief sound and the display will show all display segments.
• The system is now reset to factory settings.
Alternatively, you can also simply remove the batteries. After the display has
gone out, wait for approx. 5 seconds before re-inserting the batteries.
The alarm clock must not be connected to the plug-in mains adapter for this.
53